Hi All,
Moving along with adding all the little brackets to the main fuselage structure, I was looking at the floor board supports.
The plans specify 0.050" sheet bent to a 3/4" width with 3/8" flanges.
I was going to look into fabricating these, but then I noticed I have 3/4" X3/4" rectangular tubing with a thickness of 0.049", and I was thinking I'd just slice that in half lengthwise (with a thin cut-off wheel, so I'll be losing a 1/16" of material) and use that.
Anyone see a reason not to do this?
Thanks.
Floor boards supports
-
orchardair
- Posts: 215
- Joined: Thu Apr 08, 2010 4:56 pm
Floor boards supports
Hatz Classic plans# 136
-
dougm
- Posts: 498
- Joined: Wed Mar 17, 2010 2:39 pm
- Location: Douglas, MA
- Contact:
Re: Floor boards supports
Exactly what I did. Go for it.
Doug
Building Hatz Classic s/n 093 & Rotec R3600
Hatz Webmaster
Building Hatz Classic s/n 093 & Rotec R3600
Hatz Webmaster
-
orchardair
- Posts: 215
- Joined: Thu Apr 08, 2010 4:56 pm
-
jwhanson
- Posts: 96
- Joined: Tue Mar 16, 2010 11:55 pm
Re: Floor boards supports
I did it the same way.
John Hanson
John Hanson